MYLAR® 30PCR1C

Product Description

Mylar® 30PCR1C is a film produced using nominal 30% Post Consumer Recycle (PCR) material. It is chemically treated on one side for ink adhesion, and Corona treated on the opposite side to minimum 52 dynes. Film is used for a variety of industrial applications.

Typical Properties

Available Thickness [Gauge] 48;    92

Property Thickness Value Units Test OPTICAL Haze  48  3  %  ASTM D1003  Haze  92  4  %  ASTM D1003    PHYSICAL Elongation at Break MD  48  130  %  ASTM D882A  Elongation at Break MD  92  135  %  ASTM D882A  Elongation at Break TD  48  100  %  ASTM D882A  Elongation at Break TD  92  105  %  ASTM D882A  Tensile Modulus MD  48  500,000  psi  ASTM D882A  Tensile Modulus MD  92  500,000  psi  ASTM D882A  Tensile Modulus TD  48  530,000  psi  ASTM D882A  Tensile Modulus TD  92  540,000  psi  ASTM D882A  Tensile Strength MD  48  25  kpsi  ASTM D882A  Tensile Strength MD  92  25  kpsi  ASTM D882A  Tensile Strength TD  48  30  kpsi  ASTM D882A  Tensile Strength TD  92  30  kpsi  ASTM D882A    THERMAL Shrinkage MD (150℃)  48  1.5  %  Unrestrained @ 150℃/30 min  Shrinkage MD (150℃)  92  1.0  %  Unrestrained @ 150℃/30 min  Shrinkage TD (150℃)  48  0.5  %  Unrestrained @ 150℃/30 min  Shrinkage TD (150℃)  92  0.1  %  Unrestrained @ 150℃/30 min

Contact Info

Mylar® Specialty Films U.S. Limited Partnership 3600 Discovery Drive Chester, VA 23836-6436 USA Tel: (800) 635-4639 Fax: (804) 530-9867

Disclaimer

Note: These values are typical performance data for Mylar® Specialty Films' polyester film; they are not intended to be used as design data. We believe this information is the best currently available on the subject. It is offered as a possible helpful suggestion in experimentation you may care to undertake along these lines. It is subject to revision as additional knowledge and experience is gained. Mylar® Specialty Films makes no guarantee of results and assumes no obligation or liability whatsoever in connection with this information. This publication is not a license to operate under, or intended to suggest infringement of, any existing patents. CAUTION: Do not use in medical applications involving permanent implantation in the human body (Mylar® Specialty Films Medical Policy). For other medical applications, see the Medical Caution Statement. Mylar® Specialty Films accepts no liability for use of it's products in medical applications not reviewed and approved by Mylar® Specialty Films or for product misuse. Mylar® Specialty Films supplies products to an agreed specification and does not manufacture products designed specifically for medical end use. Melinex®, Mylar® and Melinex® STTM are registered trademarks of Mylar® Specialty Films U.S. Limited Partnership.