| |
|
MELINEX® STCH22UV is a UV and heat stabilized high clarity polyester film with good handleability and high visible light transmission. It also blocks UV transmission below 375 nm. The film is pretreated on both sides of the film surfaces for adhesion.
|
| Available Thickness [Gauge] |
|
200
|
|
|
| Property |
Thickness |
Value |
Units |
Test |
|
OPTICAL
|
| Haze |
200 |
<1 |
% |
ASTM D1003 |
| Total Light Transmission (TLT) |
200 |
91 |
% |
ASTM D1003 |
| UV Optical Density |
200 |
0.6 |
|
McBeth TD904 Optical Densitometer with Wratten 18A UV filter |
|
|
|
PHYSICAL
|
| Elongation at Break MD |
200 |
180 |
% |
ASTM D882A |
| Elongation at Break TD |
200 |
100 |
% |
ASTM D882A |
| Tensile Strength MD (break) |
200 |
24,000 |
psi |
ASTM D882A |
| Tensile Strength TD (break) |
200 |
33,000 |
psi |
ASTM D882A |
| Yield Strength MD 5% |
200 |
13,500 |
psi |
ASTM D882A |
| Yield Strength TD 5% |
200 |
12,500 |
psi |
ASTM D882A |
|
|
|
THERMAL
|
| Shrinkage MD (150℃) |
200 |
0.1 |
% |
Unrestrained @ 150℃/30 min |
| Shrinkage TD (150℃) |
200 |
0 |
% |
Unrestrained @ 150℃/30 min |
|
|
Mylar® Specialty Films U.S. Limited Partnership
3600 Discovery Drive
Chester, VA 23836-6436 USA
Tel: (800) 635-4639
Fax: (804) 530-9867
|
Note: These values are typical performance data for Mylar® Specialty Films' polyester film; they are not intended to be used as design data. We believe this information is the best currently available on the subject. It is offered as a possible helpful suggestion in experimentation you may care to undertake along these lines. It is subject to revision as additional knowledge and experience is gained. Mylar® Specialty Films makes no guarantee of results and assumes no obligation or liability whatsoever in connection with this information. This publication is not a license to operate under, or intended to suggest infringement of, any existing patents.
CAUTION: Do not use in medical applications involving permanent implantation in the human body (Mylar® Specialty Films Medical Policy). For other medical applications, see the Medical Caution Statement. Mylar® Specialty Films accepts no liability for use of it's products in medical applications not reviewed and approved by Mylar® Specialty Films or for product misuse. Mylar® Specialty Films supplies products to an agreed specification and does not manufacture products designed specifically for medical end use.
Melinex®, Mylar® and Melinex® STTM are registered trademarks of Mylar® Specialty Films U.S. Limited Partnership.
|
|
Show Printable Version