| |
|
Melinex® DCS1 is a tough, general purpose translucent film which is one-side pretreated for antistat. Melinex® DCS1 has a rough surface to provide ease of handling, good adhesion, and processability used for industrial applications such as cover sheets for flexographic printing plates.
|
| Available Thickness [Gauge] |
|
400
|
|
|
| Property |
Thickness |
Value |
Units |
Test |
|
OPTICAL
|
| Haze |
400 |
45 |
% |
ASTM D1003 |
|
|
|
PHYSICAL
|
| Density |
400 |
1.3954 |
g/cc |
|
| Elongation at Break MD |
400 |
195 |
% |
ASTM D882A |
| Elongation at Break TD |
400 |
110 |
% |
ASTM D882A |
| F5-MD |
400 |
13.5 |
kpsi |
ASTM D882A |
| F5-TD |
400 |
14 |
kpsi |
ASTM D882A |
| Tensile Modulus MD |
400 |
490,000 |
psi |
ASTM D882A |
| Tensile Modulus TD |
400 |
560,000 |
psi |
ASTM D882A |
| Tensile Strength MD |
400 |
26 |
kpsi |
ASTM D882A |
| Tensile Strength TD |
400 |
35 |
kpsi |
ASTM D882A |
| Yield (nominal) |
400 |
5,000 |
in²/lb |
|
|
|
|
THERMAL
|
| Melting Point |
400 |
254 |
C |
|
| Shrinkage MD (150℃) |
400 |
1.0 |
% |
Unrestrained @ 150℃/30 min |
| Shrinkage TD (150℃) |
400 |
1.0 |
% |
Unrestrained @ 150℃/30 min |
|
|
Mylar® Specialty Films U.S. Limited Partnership
3600 Discovery Drive
Chester, VA 23836-6436 USA
Tel: (800) 635-4639
Fax: (804) 530-9867
|
Note: These values are typical performance data for Mylar® Specialty Films' polyester film; they are not intended to be used as design data. We believe this information is the best currently available on the subject. It is offered as a possible helpful suggestion in experimentation you may care to undertake along these lines. It is subject to revision as additional knowledge and experience is gained. Mylar® Specialty Films makes no guarantee of results and assumes no obligation or liability whatsoever in connection with this information. This publication is not a license to operate under, or intended to suggest infringement of, any existing patents.
CAUTION: Do not use in medical applications involving permanent implantation in the human body (Mylar® Specialty Films Medical Policy). For other medical applications, see the Medical Caution Statement. Mylar® Specialty Films accepts no liability for use of it's products in medical applications not reviewed and approved by Mylar® Specialty Films or for product misuse. Mylar® Specialty Films supplies products to an agreed specification and does not manufacture products designed specifically for medical end use.
Melinex®, Mylar® and Melinex® STTM are registered trademarks of Mylar® Specialty Films U.S. Limited Partnership.
|
|
Show Printable Version